Each Speed Input has a range of settings that must to be configured to match the input type.


Sensor Type


  • Magnetic. 
  • Hall Effect
  • Logic 
  • Switch.


Active Edge


  • Rising
  • Falling
  • Both
  • Off



Pull Up


Can be used to switch on a 9V pull up resistor.



Scaler


Scales the frequency based input into kph or into the units that have been selected. The raw frequency value can be viewed from the Runtime Menu -> Raw Inputs Tab.



Arming Thresholds


Each channel when assigned between DI 1-8 can have two options for arming threshold control; 2 point or Table.


NOTE: It is recommended on ALL frequency based Magnetic inputs that the Table option is used. This allows better signal integrity control due to the improved functionality offered by the table.


Scaler Calculation


Scaler = Number of Sensor Teeth / Wheel Diameter(cm) * 3180

Scaler = 360 when using CAN Speed Inputs