Control Rate



The rate at which the PID control algorithm calculations are performed.



Typical : 10 Hz



Idle Deadband +/-



The output control signal is held constant when the Input Signal (RPM) falls within the deadband range of the Setpoint (Idle Target). This helps reduce steady state error and oscillations.



Typical : 20 RPM



RPM Filter



Filters the RPM signal to allow better PID control



Typical : 5



Integral Positive/Negative Clamp



Allows the user to set the minimum and maximum I gain compensation used by the closed loop system.  



Re-entry Delay



Delay once all lockouts are cleared before Closed Loop Idle Control becomes active.



** Will immediately become active if engine speed falls below the Target RPM